On this page
This guide covers the rehearsal around the tape, not the acting. It sits next to how to use a teleprompter and reading a script on camera naturally, which cover setup and delivery for creators.
What the brief decides before you rehearse
A self-tape is judged remotely and quickly, so start with what you were asked to send. Backstage’s coaching article notes that most requests come with specific instructions about lighting, framing, sound, file names and the reader, and that some warn a tape can be rejected if one step is missed. Reading them twice costs minutes. Missing one can cost the tape.
Write down from the brief:
- the maximum length and file format of each scene
- whether to slate, and what a slate should say
- the framing asked for, and the orientation of the video
- the file name and the way to send it
- how the reader should read, and where they should sit
Everything below gives way to these points. Where this guide and the brief differ, follow the brief.
Six steps, in order
- Learn the scene as a scene. Read it aloud, not silently, because that is how you will perform it. Learn the cues and the thought behind each line, not only the words.
- Decide how you will hold the script. The sources split. A SAG-AFTRA workshop summary says casting assumes you are off-book for self-tapes and that seeing sides in the frame is distracting. It suggests taping a few key moments to the tripod to glance at. The Backstage article says memorizing is best but not required, and suggests keeping the script in hand so the performance reads as flexible. If you use a prompter instead, keep it a safety net for a few lines, and know the scene well enough to look at the camera for most of it.
- Time the scene against the length limit, using the table below.
- Test the setup. Record a few lines and watch them. Backstage suggests checking whether the light looks blown out, how your clothes look against the background and whether you can be heard on a laptop at normal volume.
- Run short takes. Record the whole scene, stop, watch it back and change one thing before the next take.
- Choose the take where the sound, light and eye line are clean and the scene is alive. Then check the file against the brief.
How long will the scene run?
Divide the words by your pace in words per minute. The table uses three example paces for a scene read aloud; acting adds pauses and beats, so treat each figure as a lower bound. The arithmetic is the same as in words per minute for a speech, where you can find a way to measure your own pace.
| Words in the scene | At 100 wpm | At 130 wpm | At 150 wpm |
|---|---|---|---|
| 200 | 2:00 | 1:32 | 1:20 |
| 300 | 3:00 | 2:18 | 2:00 |
| 450 | 4:30 | 3:28 | 3:00 |
Count only your own lines and the reader’s lines that you wait through, and add a few seconds for each pause you plan. If the total is over the limit, ask yourself whether you are rushing to fit it. A tape that is a little short and clear is easier to watch than one that is squeezed.
Where your eyes go
A self-tape is a close-up. The viewer sees your eyes, and a glance down or sideways at a script reads as looking away, unless the character is looking away. Two habits help.
First, give your reader a fixed spot. Backstage advises putting the reader as close to you as possible while off camera, just to the right or left of the lens. Aim your eye line at their face, not at the lens, when the scene is a conversation, and keep it in the same place for every take. Backstage also notes that it does not matter if the reader does not match their character: you are the one auditioning.
Second, choose where the words sit if you use a prompter. Text placed right beneath the lens keeps your eyes closest to the camera. A script lying on a table or taped to a wall sends them elsewhere. Whichever you choose, rehearse with the same arrangement you will record with, so that your eyes find the words without searching.
Sound, light and frame
The sources are blunt about the technical side. The SAG-AFTRA workshop summary calls poor audio the biggest distraction in video and says built-in microphones in most cameras and phones are not sufficient. Backstage quotes a television director who says it is important that you are well lit and can be heard, and notes that a viewer may click away if the footage is too dim or too quiet.
A short checklist, before every session:
- Face the light source, so it falls on your face and not behind you.
- Use a plain, non-shiny background that does not compete with you.
- Frame from the middle of your chest to just above your head, centred, as Backstage describes.
- Shoot the audition takes in landscape. The SAG-AFTRA workshop mentions turning the phone to portrait only for a full-body slate in a small room.
- Keep the camera still. Backstage advises one fixed position and no fancy camera moves.
- Play a few seconds back with headphones, and with the speaker at normal volume.
Rehearsal that follows your pace
Most self-tape time goes on repeating the same lines. One way to make the repeats useful is to read the scene aloud at your natural pace, note how long it takes, and work from that. A rehearsal tool should follow the pace you really use, not the one you wish you had.
Here is the plan we would use with a prompter.
- Put the scene in as text. Write the reader’s lines in capitals or in brackets so you can tell them apart at a glance.
- Rehearse aloud once at the pace you will really use, with the text moving along as you read.
- Read the pace off the script screen as words per minute, and compare it with the table above to see how close you are to the length limit.
- Record a take, with the text in a window just under the lens in portrait, and watch it back.
- Change one thing. A different beat, a pause where you rushed, a new eye line.
- Rehearse again if the scene has changed, and take the new pace.
Keep a few honest limits in mind. A prompter reading at your pace does not listen to your voice, so it will not wait for the reader, and a long pause in a scene is yours to manage. It is also a rehearsal aid, so use the last takes to look at the lens and let the text drop to a glance.
A rehearsal session in 40 minutes
The numbers below are a template, not a rule. Adjust them to the length of your scene.
| Minutes | What you do |
|---|---|
| 0 to 5 | Read the brief and write down the length, slate, framing and file name |
| 5 to 15 | Learn the scene aloud, one beat at a time |
| 15 to 20 | Time it, set up the camera, light and reader, and test sound |
| 20 to 35 | Record three or four takes, watching each one back |
| 35 to 40 | Pick the take, check it against the brief and name the file |
If a scene is long, rehearse it in sections and record each section on its own. Backstage advises shooting scenes separately and editing them together afterwards, unless the instructions say otherwise.
Before you send it
- The take matches every point of the brief: length, framing, slate, file name.
- The sound is clear on a laptop at normal volume.
- Your face is lit and centred.
- Your eyes are where you meant them to be for most of the scene.
- You have watched the whole file once, start to finish.
Rehearsal exists so that you can forget it on the day. The better you know the scene, the less of the text you need to see, and the more of the take is you looking at the person across from you.
Frequently asked questions
Can I use a teleprompter for a self-tape?
Should I slate at the start of a self-tape?
Landscape or portrait for a self-tape?
How many takes should I record?
Products mentioned
Products from the Store that this post mentions.
- CueliftRehearse once. The prompter keeps your pace.Android: Available



